![]() This is to properly calibrate the lock to the door it’s installed inside, and will be as simple as locking and unlocking the door a few times in a row. Once the batteries are in, your lock will likely prompt you to walk it through a few tests. Just pop the compartment cover off (or use a flat-head screwdriver to gently pry loose), insert your manufacturer-provided batteries, and re-secure the cover. In our case, it was right on top of the interior housing. Your new lock’s battery compartment will be easy to locate. Our demo unit simply pops into place and locks. Many locks will use screws to secure the lock to the plate. Connect the cable to the interior portion, then hang the interior on the mounting plate. The back will have a female connection for the exterior wire. The front of this piece should feature the familiar thumb-turn mechanism. Get both screws nice and tight, and then grab the interior portion of your new lock. You may have a bit of trouble getting the screws to align with the deadbolt, but once you’ve successfully threaded one, it’ll help to pull the other hole into alignment with the screw. Grab those bad boys, insert into the two screw holes of the mounting plate, and screw them in. Next, your new lock should have come with two longer mounting screws. First, grab that ribbon cable and slide it through the bottom opening of the mounting plate. The interior sides of many smart locks will feature some kind of plastic or metal mounting plate. Oh, and if you’ve got some painter’s tape handy, stick a piece over your lock to hold it in place as you work on the interior. If all is well, retract the deadbolt before moving on to the next step. The deadbolt should extend and retract without resistance. To test, you can grab the flat bar spindle and turn it to the left and right. The lock’s spindle bar should slide through the center hole of your deadbolt assembly (between the two now-empty screw holes). Slide the wire underneath the deadbolt, and then insert the exterior lock into the framing. This piece will feature a ribbon-like electrical cable and a flat bar spindle. Next, you’ll want to grab the exterior-facing half of your lock. There’ll be some kind of indicator to mark where the top of the assembly should be, such as an arrow-up symbol or the word “Top.” Make sure the deadbolt is retracted, and then secure the assembly to your door with the two manufacturer-provided screws. Most deadbolts will allow you to twist and pull the assembly to adjust the length.Īfter you make your adjustments, insert the deadbolt into the door. In that case, all you’ll need to do is extend your deadbolt before sliding it in. There’s a small chance your dimensions will be slightly larger. Before installing, you’ll first want to measure from the edge of your door to the center of the deadbolt hole. Your new smart lock will have its own deadbolt assembly. Then, open your door up and remove the exterior plate (where you would insert a key). Once the screws are out, you should be able to pull off the interior plate. If you ever want to reinstall it somewhere else, you’ll need the old screws and assembly.įor most original locks, the first thing you’ll want to do is grab your screwdriver of choice and remove the two Phillips head screws that connect the main lock to your deadbolt assembly. Use it to keep your old lock hardware in one safe and sealed place. First and foremost though, have a sandwich bag handy. Step 1: Remove your old lock and deadbolt For most smart lock brands, the install fundamentals will be the same, but some brands may require additional steps for setup. We’ve put together a step-by-step guide for the average smart-lock install, using a Securam Touch as our demo unit. The benefits are a no-brainer, but what about the install? Is this a job you need to hire someone for? With a few tools, your phone, and a little bit of patience, you can DIY install a smart lock. ![]() Step 4: Install the new interior portion.Step 3: Install the new exterior portion.Step 1: Remove your old lock and deadbolt.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |